HATs and other add-ons • Re: M.2 Hat+ without GPIO pins
Okay, thank you both of you.Statistics: Posted by Sebastian147 — Fri Dec 06, 2024 11:05 am
View ArticleTroubleshooting • Re: Can I use the RPi Debug Probe on a Pi 4
Did you follow the suggestions in the boot problem sticky as thagrol suggested?If so what were the results?I'm not aware of what debug probe you have, perhaps providing us with a link would help?I did...
View ArticleMicroPython • Re: PicoW MicroPython project: I added a bunch of debug lines...
...If I was tackling the code to read some temperature sensors, display the results on a touch screen ili9341 and run a small web server etc. then the use of the following micropython libraries will...
View ArticleRaspberry Pi OS • Re: The quiet disintegration of Raspberry Pi OS Lite
Sometime recently, the Raspberry Pi OS team introduced breaking changes to the camera subsystem. While retaining some parts of the older infrastructure under a "legacy" banner, the team standardized...
View ArticleClik here to view.
Raspberry Pi Connect • Re: Screen Sharing high latency Raspberry 5 headless
Hello, sorry for the late reply didn't see you responded, according to the screenshot it is using Connect's relay. It it the most optimal ? How can I make sure I don't get this high latency ? The...
View ArticleClik here to view.
Compute Module • Re: SD card not detected on Non-eMMC CM4
Do you happen to another Raspberry Pi ? If so, does that SD card boot in that ?The Geekworm 650 appears to bring out the USB2 OTG interface if you short nRPIBOOT and GND so you could use USB-device...
View ArticlePython • Re: boolean conversion problem
Couldn't figure out the dead link above but here's the official Python doc for bin()https://docs.python.org/3/library/functions.html#binStatistics: Posted by Paul Hutch — Fri Dec 06, 2024 12:14 pm
View ArticleSDK • Re: DMA not fireing IRQ
Your problem is here:Code: dma_irqn_set_channel_enabled(LCD_DMA_IRQ, lcd_dma_chan_rx, true); // PIOthe first parameter should be 0 or 1 for DMA_IRQ0 vs DMA_IRQ1, but the symbol DMA_IRQ_0 has the value...
View ArticleClik here to view.
Beginners • It wasn’t dead after all (pi 4 Doesn’t boot)
Just to close out something.I bought a pi4 8GB ages ages ages ago.Tried to install it, having already set up a 2Gb and 4Gb successfully, but the 8Gb would not boot.I tried numerous times to no avail,...
View ArticleBeginners • Re: M.2 HAT+ and Official Pi 5 Case
I think this one might work. I haven’t tried ithttps://www.amazon.co.uk/Miuzei-Raspber ... B0D46W6NR2Or potentially this one https://www.amazon.co.uk/ElectroCookie- ... B0CV7GN22GAlso waiting to...
View ArticleBare metal, Assembly language • Re: MMU Intermediate Physical Address size
Pete, I tried to understand your MMU problem, because you asked. I stripped down your kernel.s file to the point, where the MMU has been enabled and the code runs through to this point. I can see this...
View ArticleGeneral discussion • Re: What Will Happen to Raspberry Pi Zero 2W If You...
Because i am so scared that i might fried my raspberry pi zero 2w that if i connect 2 micro usb at the same timeIt is very unlikely to damage the Pi.It might damage one or both of the power supplies...
View ArticleAdvanced users • Re: NUMA Testing
Let me start by describing what I have here: two Raspberry Pi 5's 8Gb. Both of them from the same batch (Pi store in Cambridge UK, before people started receiving them at home). One has meaningful...
View ArticleOff topic discussion • How reach the moderators ?
Hi,I'm new here, I've posted two Topics, and the newest has been already approved by moderators , but the first one is still pending...This post is not visible to other users until it has been...
View ArticleTroubleshooting • Re: Raspberryi card shows message
" So is this message originating from the card"YesStatistics: Posted by neilgl — Sat Dec 07, 2024 12:25 pm
View ArticleClik here to view.
Troubleshooting • Re: Pico W after connecting to laptop shows 2x on laptop
When I do this it downloads the uf2 onto the Pico. Then it disconnects. when it plug it back in and open Thonny (my preferred IDE)it says "unable to connect to COM3: port not found Process ended with...
View ArticleAdvanced users • Re: Image File Utilities
You can download image from here: https://github.com/openhab/openhabian/releases I just wrote 'openhabian-raspios64-latest-202411011242-crc463de44d.img' to a USB SSD connected to a Raspberry Pi 5. I...
View ArticleClik here to view.
General discussion • Re: Air holes for the official case (results)
I have found that unclipping the top of the case & just resting it there keeps the RPi5 at a lower temperature in our somewhat hot Summer last year, so I would be tempted to open up the gap...
View ArticleOff topic discussion • Re: How reach the moderators ?
The requested topic does not exist.So, it looks like it didn't make the cut.Was it, by any chance, a dup of the one that did go through?Statistics: Posted by BigRedMailbox — Sat Dec 07, 2024 12:32 pm
View ArticleGeneral discussion • Re: How can I install Raspberry PI specific VLC?
If you're running PiOS (lite) the preferred version should be the one from the Pi repos.You can check that with Code: apt policy vlcHi,Thank you for the response, I can see below result for command.....
View Article